If you have multiple peristaltic pumps, you can dose a multi-part solution in a defined ratio.
If you have multiple peristaltic pumps, you can dose a multi-part solution in a defined ratio.
To add a Peristaltic Pump to your Nutrient Controller, simply plug it in. It will be recognized as much as 100 feet away with clear line of sight. If there are walls or other obstructions, the range may be more limited.
To connect your Controller to a different Wi-Fi network other than the one it is currently configured for, press and hold the Setup button for approximately 15 seconds until the light flashes blue rapidly. (The Setup button is the Bottom button.) Release the Setup button and the light will start blinking blue. The Controller is back in Listening Mode.
Scheduled rules are used to turn devices on and off based on a schedule. For example, you can have the lights turn on every day between 6:00 PM and 10:00 AM.
Timers are used to turn a device on and off on a regular basis. For example, you might want to turn on your irrigation system every ten minutes for five minutes. (On for five minutes, off for five minutes.)
Sensor triggers are used to turn devices on and off based on sensor data readings. When a sensor value reaches a specified threshold, it will turn a device on. For example, you can set a trigger that will turn on the air conditioning when the temperature exceeds 85 degrees.
Alerts are used to notify you when a sensor reading reaches a specified threshold. For example, you can receive notification any time the temperature exceeds 75 degrees.
One account can manage multiple Growlink Controllers at one location. For each additional Controller, follow the same steps that you did to set up your first Controller.
To connect a Wireless Power Link, simply plug it in. It will be recognized as far as 100 feet away with clear line of sight. If there are walls or other obstructions, the range may be more limited.
Before you get started, make sure you have everything you need to set up the Growlink Nutrient Controller: